Monday, August 28, 2017

Support Arm Systems - The Link Between Man and Machine

Support arm systems have proven their worth as an ergonomic link between machine, operating equipment and personnel, but the demands they are subjected to are increasing all the time. With support arms, control panels can be easily and accurately turned, lifted and swivelled so that operators can monitor their machine at any time.

Nowadays, these systems should be quick to assemble, simple to adjust, suitable for individual installations, designed in a uniform way, capable of bearing high loads and must facilitate cable management.

What is needed is an intelligent modular system with a consistent design over a wide range of loads. A wide-ranging modular system that offers the user consistency in terms of function, installation and project planning, in one uniform design and covers all the load ranges up to 180 kg that the market calls for.

Support arm systems can be created for the 60, 120, and 180 kg load levels (relative to a jib length of one metre) with a uniform function, installation and project planning system. The arm system, consisting of support section, intermediate hinge and angle pieces, can be mounted on top of a machine or on a side panel. Wall and base mountings, as well as flexible top-mounted joints and wall mounted hinges, are available with horizontal outlets for assembly. In addition, system adaptors permit adaptation to the next size down of support arm reducing the weight at the end of the jib and cost of the system.

With no need to dismantle, the system already installed can be adjusted with ease or their rotation range can be limited retrospectively. So user-friendly, all that is required is to remove the cover plate of the relevant arm component and manipulate the screws with a screwdriver.

To avoid unwanted electrical interference, support sections are also available as open versions with an X-shaped geometry. This version, in lengths of 500, 1,000 and 2,000 mm, offers the user two separate cable ducts in one section to allows control cables and power supply to be laid separately from one another. Removable covers on angle pieces, couplings and joints enable easy access. Through the open section, which complies with IP 54 protection category, the user can quickly and easily install cables - even with a DVI or VGA configured connector.

So far there has been no validation for support arm systems that specifies safety in electrical installations, thus just how plant constructors build safe operating solutions from an electrical engineering perspective lies within their own discretion and ultimately, something that is not often considered, within their own area of responsibility.

In electrical terms, many installations are now no longer state-of-the-art. Cable installations within support arm systems often lack any passive internal safety devices, such as edge protection elements to prevent chafed cables. Automatic potential equalisation should be standard with a support arm system, without any extra work and additional costs to users.

Where previously the focus has been on the mechanical structure, cable installations within these systems often had no passive internal safety devices, such as edge protection elements, to prevent chafed cables. Active protective measures were also absent, such as automatic potential equalisation throughout all the elements of a support arm system to protect the operator from live electrical voltage in the event of a defective cable.

With a support arm system all the rotating elements have so-called sliding contacts to ensure a reliable electrical contact throughout the entire system. Clever edge protection elements made of plastic, which can simply be clipped onto the inner section between extrusions and corner pieces, prevent cables from becoming pinched or chafed.

As an integrated modular system a support arm system offers plant constructors uniform function, assembly and engineering solutions in one design, offering major time savings during assembly, adjustment, and service.

Wednesday, August 9, 2017

Top 7 Proven Home Remedies for Leucorrhea Treatment

Excessive vaginal discharge, foul smell, spotting on underwear - yes we are talking about the leucorrhea. Leucorrhea is one in most filthy female vaginal infections. This condition is enough to make the women feel peeved and uncomfortable. It is awful but these days it has become a common problem among the females. To manage this vaginal infection, leucorrhea natural treatment is fruitful.

It is scientifically proven that to treat the leucorrhea naturally, use of home remedies is quite effective.

Why does leucorrhea haunt the females?

Female's genital parts are moist and covered most of the times that's why females are highly prone to this infection.

Possible causes of leucorrhea

Poor genital hygiene
Hormonal imbalances
Improper lifestyle
Unhealthy eating habits
Bacterial and fungal infections
Genital wounds due to excessive itching
Diseases like menorrhagia and diabetes
Indigestion
Constipation
Anemia
Stress and anxiety
Here we are listing the Top 7 Proven home remedies for Leucorrhea Treatment

Banana

Bananas are considered as an effective home remedy to treat leucorrhoea naturally. Being disinfected in action Banana helps to extrude the harmful microorganism from a vagina.

Directions to use

One can consume one to two overripe bananas daily.
Repeat it until you observe the noticeable change.
Ladyfinger (Okra)

Ladyfinger also comes in the category of effective home remedies for leucorrhoea. Mucilaginous nature of ladyfinger helps in the elimination of mucus from a body. In leucorrhea, it works well to reduce the vaginal discharge.

How to use

Take ladyfingers, wash them and cut into small pieces.
Boil these pieces 15-20 minutes in the water until water is reduced to half.
Allow cooling and strain it.
Add some honey and consume 2-3 times in a day.
Pomegranate

Therapeutic properties of this fruit help to ward off the vaginal infections. Fruit, its leaves, and rind are very helpful to treat the leucorrhea. Hence, it is an effective home remedy to treat leucorrhoea naturally.

How to use

Consume one glass of fresh pomegranate juice daily for one month.
Grind 25-30 fresh pomegranate leaves with 8- 10 black pepper.
Add this mixture in half glass of water.
Strain and drink it two times every day until you observe a noticeable change.
Another option makes powder of dried rind of a pomegranate.
Make the powder of dry the rind of pomegranate.
Mix 1/2 to one tablespoon of this powder in 3-4 cups of water.
Use this solution as a vaginal spray.
Fenugreek Seeds

Fenugreek seeds are loaded with the immunity booster properties. In leucorrhea, this helps to balance the pH level and micro flora in a vagina.

Directions to use

Take two- three teaspoons of fenugreek seeds in 3-4 cups of water and boil for 25-30 minutes.
Strain and let it cool.
One can use this water as a vaginal wash many times daily until the symptoms get lessen.
Indian Gooseberry (Amla)

Being a good source of vitamin c, it helps to boost up the immune system. Moreover, Amla is loaded with the antimicrobial properties that help to ward off vaginal infections.

How to use

Make a thick paste by mixing one - two teaspoons of Indian gooseberry powder with honey. Consume it two times in a day.
Another option is to boil one teaspoon of dried Indian gooseberry root powder in one cup of water until it reduced to half. One can add little sugar or honey as per taste. Eat it on an empty stomach every morning.
Cranberry

Cranberries packed with the antimicrobial, antifungal and antioxidant properties. These properties help to fight against the bacterial, viral and fungal infections. In leucorrhea, cranberry helps to eliminate the bacteria from vaginal wall.

How to use

Drink one glass of fresh cranberry juice once or twice for best results.
Fig

To manage the leucorrhea, consumption of figs is very good. Laxative action of figs helps to eliminate the toxins and waste materials from the body. They work in an amazing way to resolve the problem of excess white vaginal discharge.

How to use

Soak 5-6 figs in overnight in one cup of water. Next step in morning is to blend the soaked figs in water. Consume this solution on an empty stomach.
Alternatively, you can grind the equal quantities of the bark of the fig tree and banyan tree to make a fine powder. Add half -one tablespoon of this powder in two-three cups of water. Use this solution as a vaginal wash.
Additional tips

Maintain the proper hygiene.
Wash your undergarments daily and let them dry under the sun.
Don't wear dirty, tight or synthetic undergarments
Change undergarments at least 3-4 times daily.
Wash the vaginal area and surrounding area.
Wipe from front to back after using the toilet.
Avoid oily foods.
Avoid coffee, alcohol and aerated drinks.
Dr. Vikram Chauhan (MD - Ayurveda) Is an expert herbal practitioner based in Chandigarh and participating in Mohali, India. He is spreading the knowledge of ancient healing treatment of Ayurveda not only in India but also abroad. He has researched age old formulas from ancient Ayurvedic text books to restore health and save human beings from the worst side-effects of chemical based treatments. He is the author of 'Ayurveda- God's Manual For Healing', an informative book for people interested in learning the basics of Ayurveda, diet and principles of healing according to Ayurveda.